VCSELs  | Communication Lasers  | Photodiode Receivers | Fiber Optical Transceivers  | WDM/CWDM |On Sale Items 

Blue, Green, Red & Infrared Laser Modules  | Laser Diodes | Laser Accessories  | Laser Products  | LED Modules  | Book Store

GMP- Series 532 nm DPSS <1mW Class II Laser Modules Designed for IEC 60825-1, EN 60825-1, and JQA (Japan Quality Assurance) Compliances 

 

Key Features:

  • Automatic power control (APC) circuit with limited current to protect the green laser module

  • Low operating current

  • Output power stability 5%

  • Compact size

  • Better beam quality with the glass beam expander and the glass collimator 

  • Designed for IEC 60825-1, EN 60825-1, and JQA compliances

Specifications of GMP- Series 532 nm DPSS Green Laser Modules 
Model No. 

GMP-532-1F3-JPY-G

Wavelength 532 nm
Mode TEMoo
Output power (mW) @ 3VDC, 25 oC 0.5-0.99 
Laser class class II
Laser beam off the center axial of brass housing £+/-5 degree (Y= blank); £+/-3 degree (Y=B3); £+/-1.5 degree (Y=B1)
Operating Current (A) <0.30
Operating Voltage  3V DC
Circuit Design

APC with limited current, CW operation mode, meets Single Fault Failure Requirements for IEC 60825-1, EN 60825-1, and JQA (Japan Quality Assurance) compliances

Stability* £ ±5% @ the constant temperature 
M2 < 2
Linewidth < 0.1 nm
Polarization Linear
Lens the glass beam expander, the glass collimator, plastic focus lens
Beam Divergence  <1.2 mrad
Beam Diameter (1/e2) < 2 mm
Connector Standard: Black wire (-);  red wire & brass case (+)
Length of wires 10 cm
Storage Temperature 10 - 50 oC
Optimum Operating Temperature 20 - 30 oC
Expected Life Time** >3,000 hr
Dimensions (LxW)

Dia. 12mm x L. 35.3+/-0.5 mm (green laser head),

W. 12 x L. 20 mm (driver circuit board)

*Additional heat sink or cooling fan may be needed to stabilize the output power of laser module if the laser module is operated continuously in a period of time.

** The expected life time of green laser module is based on the MTTF (Mean Time To Failure) rating of 808nm laser diode used in the green laser module.

The GMP-series 532 nm Diode Pumped Solid State Green Laser Modules, which use laser diode pumped Nd:YVO4 crystal coupled with KTP as a frequency doubbler, are designated solely as OEM components for incorporation into the customer's end products. Therefore, they do not comply with the appropriate requirements of FDA 21CFR, section 1040.10 and 1040.11 for complete laser products. 

Note: IEC 60825-1, EN 60825-1, and JQA require the laser products to meet Single Fault Failure Requirements, which require the highest emitted power under reasonably foreseeable single fault failure conditions never higher than the laser classification. Therefore, for class II or class 2 laser products, the output power is <1mW, the highest emitted power under reasonably foreseeable single fault failure conditions for this laser shall never be >1mW. 


  Note: Specifications subject to change without notice.

If you have any comments or request for detail product information, please fill the
Quotation & Information Request Form or mail to: info@lasermate.com.

HOME  | PRODUCT LIST  | HOW TO ORDER  | QUO & INFO REQUEST  | TERMS & CONDITIONS